Controll-A-Door S series Manual de Instruções

Instruction ManualControll-A-Door®5Automatic Rolling Garage Door OpenerN1134Instruction Manual©Copyright 2001B&D AustraliaPage 1ISO9002Controll-A-

8. Re-attach the door bracket using your reference marks as a guide and tighten the bolts. Ensure that the slots inthe mounting bracket of the opener

• Switch 1: R or L. This switch selects which side of the door the opener is to be installed on -L for Left Hand, Rfor Right Hand. Changing the Left-R

All remote control transmitter codes are learned using one of the following procedures:Procedure 1:• Ensure the Power LED is ON.• Press and hold the r

Closing Forcea. The door should be in the open position with power on. b. Set the closing force adjuster initially to the minimum position.c. Press th

SECTION 4 – FITTING ACCESSORY ITEMWired AccessoriesA variety of accessory items can be fitted to the opener (eg Safety Infra Red Beamor a wall switch).

SECTION 5 - HOW TO OPERATEFor maximum efficiency of your opener, your garage door must be in good operating condition. A regular service ofthe door by

Controll-A-Door™AUTOMATIC GARAGE DOOR OPENERPOWERCODE SETLIMIT SETWARNING: Cover not to be removed except byauthorised technicianPowerLEDManual Operat

54321©Copyright 2001B&D AustraliaPage 17Changing the Light GlobeYour opener uses a 240 Volt, 25 Watt, standard bayonet Pilot Light globe. If you s

Page 18 ©Copyright 2001B&D AustraliaSECTION 6 – DIAGNOSTIC CODESThe continuous flashing of the Green Power LED on the front panel indicates there m

2 flash1 flash2 flash2 flashControll-A-Door™AUTOMATIC GARAGE DOOR OPENERPOWERCODE SETLIMIT SETWARNING: Cover not to be removed except byauthorised technic

START BY READING THESE IMPORTANT SAFETY RULESThese safety alert symbols mean Caution – a personal safety or property damageinstruction. Read these ins

Page 20 ©Copyright 2001B&D AustraliaNote: If the door has been moved more than 50mm outside the programmed limits whilst the power is disconnected

Section 8 – WarrantyControll-A-Door Automatic Garage Door Opener1. Definitions‘B&D’ means (a) in Australia - B&D Australia of 34-36 Marigold St

7. The Purchaser will pay for any service call made by B&D or an Authorised Distributor where such a call is madefor the purpose of adjustment (as

13. This warranty shall be governed by and construed in accordance with Australian law if the opener waspurchased in Australia, or New Zealand law if

Page 24059669 03/02 Allpress©Copyright 2001B&D AustraliaNSW Office: B&D Australia, 34-36 Marigold Street, Revesby 2212. Ph: (02) 9722 5555QLD O

CONTENTSSafety Rules ...p. 2Contents

ABOUT YOUR B&D CONTROLL-A-DOOR®5 OPENERThank you for choosing B&D’s Controll-A-Door®5. This automatic garage door opener has been designed and

ACCESSORIESB&D has a range of additional accessories for your added convenience and security.• Safety Infra Red Beams. Gives additional protection

SECTION 1 - REQUIREMENTSIMPORTANT SAFETY INSTRUCTIONS FOR INSTALLATIONWARNING - INCORRECT INSTALLATION CAN LEAD TO SEVERE INJURY. FOLLOW ALL INSTALLAT

Instruction ManualControll-A-Door®5Automatic Rolling Garage Door OpenerN1134Instruction Manual©Copyright 2001B&D AustraliaPage 1ISO9002Controll-A-

SECTION 3 – INSTALLATION PROCEDURESThe following is the preferred method of installing the opener Step 1: Preparationa. Check the door operation.i. Th

Step 3: PIN THE DOOR CURTAINPin the door curtain to the door drum at each end of the door to maintain securitywhen the opener closes and locks. With t